|
|
VEHICLE TECHNICAL QUESTION & ANSWER A RELIABLE ADDRESS TO ANSWER YOUR VEHICLE TECHNICAL INFORMATION |
|||
|
||||
 |
Question:
Could you help me this case, when I disconnect the connector of the injector (Vespa LX 125 ie scooter) the Motorscan can not find that fault until I restart the engine several times? Sometimes, Motoscan show three faults, I correct one of them but all the faults disappear? |
|||
 |
Answer:
Thanks for your question, it would be long lines to
help you have a deep knowledge at this, you may need the
information about the active and passive sensor, history
code, Pending/Current code, determine faults and store
faults code method of ECM by join an electronic
motorcycle training course through this link: http://dtdauto.com/Training_Help/Training_Motor_E.htm For example: For temperature sensor you only need to create a fault yourself without make the engine rotate, it is means that, you disconnect the connector plug of the sensor without rotate the engine, Motoscan immediately find that fault. For other sensors such as CKP sensor or injector control circuit, the engine has to rotate about 5 seconds then Motoscan could find faults. To determine which faults need to be repaired or unrepaired of motorcycles, you can click here for the same information for technical solutions about the basic steps to find faults using diagnosis equipments: http://dtdauto.com/Training_Help/experience_E.htm |
 |
||
.jpg){kind=small}