   |
VEHICLE TECHNICAL QUESTION & ANSWER
A RELIABLE ADDRESS TO ANSWER YOUR VEHICLE TECHNICAL INFORMATION |
||
|
|||
 |
Question: I have an imported Toyota YARIS car, the Immobilizer was faulted. I have asked a workshop to buy a new one for replacing but the engine still can not start. Could DTDAuto help me with this situation? | ||
 |
Answer: Your vehicle after replace new ECU of the immobilizer, then it will need to make a registration for connecting ID between ECM and ECU to start the engine. | ||
 Toyota Yaris immobilizer block system diagram |
|||
|
Currently, you can do it if you have specialized equipments or you can try it by hand follow these instructions:
1. Use a jump wire (or use a 100W resistor for safety reason) to connect TC with CG as the following image before insert the key into the ignition key position. |
|||
 The position of the jumper when register by hand ECU and ECM for Toyota Yaris |
|||
|
2. Insert the old key into the cylinder key and turn it on but do not start engine and wait about 30 minutes
3. Turn off the key and disconnect jump wire between TC and CG 4. Start engine and keep this start position in 3 seconds (or more) until the engine operation and you have resisted successfully Note: You should pay attention on manipulation or do addition checking if there are any other faults. |
|||
.jpg){kind=small}